a pattern of the wood end panel over the door of
the car. One of the originals was fairly well
preserved.
The first photo shows the pattern
as well as the two steel plates that were
made from the pattern. These will be fastened
over the doors and become part of the steel
reinforcement at each end of the car.
The second photo shows Bob and Lenny
clamping the plate in place. It was installed
with minimal forcing although I did wear
my earplugs.
Another view of the plate in place. Tom is
applying a clamp in the center.
A little re-shaping had to be done to fit the
wood trim. The two ends were very similar
but not identical.
The second photo shows Bob and Lenny
clamping the plate in place. It was installedwith minimal forcing although I did wear
my earplugs.
Another view of the plate in place. Tom is
applying a clamp in the center.
A little re-shaping had to be done to fit the
wood trim. The two ends were very similarbut not identical.
No comments:
Post a Comment