We continued to install the siding panels on the east end of the car. In this photo I am holding the panel in place while Craig inserts the screws from the back side.
Here he is on the other side placing screws through the wood blocks into the siding panel.
After installation, the panels were primed on the outside with an oil based primer by Bill L. and Ron.
The west end panels are installed and primed.
In this photo Bill L. and Ron are priming the cedar boards for the underside sheathing before installation.
Cutting and fitting the sheathing under the car was difficult because of the complex framing. Here Bill K. is screwing a board in place.
Meanwhile work continued on installing siding. Here Craig is cutting primed boards to fit.
These boards are going between the windows, and Craig is nailing one in place with the nail gun.
This side is looking finished.
We had some uninvited guests this summer in the form of wasps. There were nests on and in the trailer as well as in the pipe for the hand rails to the steps into the trailer. John, with deadly accuracy, took care of them, however. Fortunately no one got stung.
We had to jack up the car and move the support blocks and beams to access parts of the underside for the moisture barrier and sheathing installation. This heavy duty jack was borrowed from the Trolley Museum and made lifting the car look easy. John is doing the heavy lifting here.
This steel beam can be moved now.
In this last photo Bill K. is placing blocks in a new position under the car.
No comments:
Post a Comment